Publication | Peer reviewed papers | Potentiale, Bioenergiesysteme, Logistik
Part 2─Tailoring of Pyrolytic Char Properties with a Single Particle CFD Model with a Focus on the Impact of Shrinking, Vapor Cracking, and Char Permeability
Published 6 June 2024
Citation: Maziarka P, Kienzl N, Dieguez-Alonso A, Prins W, Arauzo PJ, Skreiberg Ø, Anca-Couce A, Manyà JJ, Ronsse F. Part 2─Tailoring of Pyrolytic Char Properties with a Single Particle CFD Model with a Focus on the Impact of Shrinking, Vapor Cracking, and Char Permeability. Energy & Fuels. 6 June 2024. Volume 38 (11): 9772 - 9793. 10.1021/acs.energyfuels.4c00942
Abstract
The prediction of the structural properties of biobased carbonaceous materials of pyrolytic origin (chars) with only base feedstock properties and process conditions still poses a challenge that hinders char tailoring for novel applications. CFD modeling of single biomass particle conversion can help solve this issue since it allows for the quantification of relations between parameters that are difficult to measure. A model for char tailoring must include a validated representation of the structural changes coupled to all other relevant phenomena occurring during conversion. Part 2 of this study focuses on finding the description of the mentioned aspects to achieve the highest precision of prediction of the structural changes in char by a CFD model. The investigation in Part 2 is composed of three cases focused on accurate description and prediction of (1) bulk density and porosity, (2) secondary vapor reactions on yields and soot formation, and (3) permeability, as well as the outflux and conversion of evolved vapors. The experimental results from Part 1 and the literature data were used to find appropriate descriptions of phenomena and assess the accuracy of the model. The model results indicate that for both particle lengths (10 and 16 mm), a high accuracy of prediction of base structural parameters was achieved. The average prediction error for temperatures between 400 and 840 °C of bulk density was 31 ± 15 kg/m3, and the porosity was 1.8 ± 1.1 vol %. The results also show a low error in the prediction of bulk product yields (dry basis) over the mentioned temperature range, which were: for char 2.8 ± 1.1 wt %, for the condensable fraction 6.5 ± 3.3 wt %, and for the pyrolysis gas 4.1 ± 1.9 wt %. The distribution of secondary char formation was found to be nonuniform below 500 °C. The changes in permeability had a minor influence on the vapor outflux but a non-negligible effect on the soot formation, especially at 840 °C. The results indicate a need for further improvement of the primary degradation model to increase the accuracy of the effect of soot formation on the char structure.